After mounting and wiring a new modular telephone jack in a star installation, where should the UTP cable from the new modular jack be connected?

The correct choice emphasizes that after mounting and wiring a new modular telephone jack, the UTP (Unshielded Twisted Pair) cable should be connected directly to the tip and ring screw terminals or the Insulation Displacement Connector (IDC) of the modular jack.

In a star installation configuration, each device or jack is connected to a central point (typically a patch panel or telephone distribution block) where the connections are made. The tip and ring terminals of a telephone jack are specifically designed for connecting the twisted pairs of the UTP cable. These terminals facilitate the transmission of voice signals by providing the necessary electrical connection, ensuring that the telephone service operates correctly.

By connecting the UTP cable to these terminals, it allows for proper signal reception and transmission. This is pivotal for ensuring that the modular jack functions as intended in a telephone network.

The other options, although they may pertain to the broader network setup, do not directly relate to the specific connection needed after installing a modular telephone jack. For instance, while connecting to the main router or internet modem could be part of a digital communication setup, it is not the correct step following the installation of a telephone jack. Connecting to a wall outlet would also not make sense immediately after wiring a new